GRAS 12AL 1-Channel CCP Power Module with A-weighting filter
Typical applications and use
- Power supply for CCP transducers and preamplifiers
- General-purposes measurements
- Precision measurements
- Wide-band measurements
- Switchable A-weighting network
- Low noise
- Battery operated
The 12AL will supply a transducer with a constant current of 4 mA. It has a wide operating frequency range from about 1 Hz (depending on load impedance) to well over 200 kHz. It also has an A-weighting filter that can be switched in or out.
The 12AL can be powered either by two internal AA alkaline batteries or from an external DC supply of 3 – 6 V. A regulated mains/line adapter AB0005 is available for supplying external DC power.
LEDs are used to indicate battery condition; green for power OK and red for battery low. Another red LED is used to indicate a cable break, short circuit, and overload.
The 12AL has zero gain since the output signal from the transducer is wired directly via 22 μF to the output connector. Zero gain is also preserved at 1 kHz when the A-weighting network has been switched in.
The size and weight of the 12AL make it a compact and handy power supply for CCP transducers both in the laboratory and in the field.
All GRAS products are made of high-quality materials that will ensure life-long stability and robustness. The 12AL is delivered with a 2-year warranty. The warranty does not cover products that are damaged due to negligent use.
Service and Repairs
All repairs are made at GRAS International Support Center located in Denmark. Our Support Center is equipped with the newest test equipment and staffed with dedicated and highly skilled engineers. Upon request, we make cost estimates based on fixed repair categories. If a product covered by warranty is sent for service, it is repaired free of charge, unless the damage is the result of negligent use or other violations of the warranty.